Masonry Single Piece Joint Hanger

Masonry Single Piece Joint Hanger, galvanised and available in 47 or 75mm wide and lengths 100mm to 225mm.

Masonry Single Piece Joint Hanger Specification

• Material: Galvanised Mild Steel DX51D+Z600 to EN10346:2015
• Coating/Finish/Colour: 600g/m² Zinc Coating
• Lengths: 100mm to 225mm, see options.
• Widths: 47mm or 75mm
• Material Gauge: 2.0mm
• Individual Weight (kg): 0.325
• Declared Load bearing Capacity: 5kN SWL (SLS)
• Fire Rating: Euroclass A1
• Fixing Type: Built into masonry - No mechanical fixings required to wall.

Installation Requirements

• Back of hanger must be tight against wall.
• Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger.
• A minimum 675mm of set masonry must be in place over support flange before loads are applied.
• Joist to be nailed through side gusset using 3.75x30mm square twisted nails.
• The underside of joists should be notched to provide a level surface for plasterboarding.

Expamet SPHS22547